• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Modified 1968 Coupe

Today I sanded the deck lid than sprayed a coat of SPI white epoxy

238.jpg


240.jpg


I waited a couple of hours than sprayed 3 coats of SPI single stage red.

242.jpg


243.jpg
 
Last edited by a moderator:
do you have pics and/or advice on removing the drip rails? I'm thinking the drag car would be cool with out them... yours looks good
 
I don't have any pictures of my coupe but here is a fastback we did. Cut off the drip rail with a cut off wheel than weld it up, grind and than use filler.

117-1.jpg


121.jpg


122-1.jpg


126-1.jpg


We will be doing a 65 Coupe soon and I will have more pictures
 
Last edited by a moderator:
This is the first one we did on this 67 coupe because of rust.

198-1.jpg


199-1.jpg


PA310002.jpg
 
Last edited by a moderator:
I sprayed SPI bedliner on fender aprons

186-1.jpg



I bonded the headlight buckets to the fender

132-1.jpg


192.jpg


A few pictures outside

187.jpg


191.jpg
 
Last edited by a moderator:
I have been behind posting pictures to catch you up to where I am at this time.


197.jpg


198.jpg


199.jpg


212.jpg


202.jpg


218.jpg


Today I added a little filler to tighten the gap from the quarters to the fiberglass deck lid and block sanded the taillight panel and roof

250.jpg


251.jpg


252.jpg
 
Last edited by a moderator:
"67 Fastback" said:
What lower valance is that?
Bill
Click to expand...

Stock valance with a patch welded to fill in the backup light holes and than the valance was welded to the body.
 
"GPR" said:
Stock valance with a patch welded to fill in the backup light holes and than the valance was welded to the body.
Click to expand...

Sorry, I meant the front.
Bill
 
You must log in or register to reply here.
Back
Top