-
Hello there guest and Welcome to The #1 Classic Mustang forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
What did you get done on your Stang today????
- Thread starter cmayna
- Start date
The wife went with her coworkers for a few drinks so I got a little late night garage time yesterday.
I got those bolts out of the shifter levers and installed my connecting rod between the AOD and stock shifter. Also replaced the lower radiator hose with a new one for a better fit. Small steps, but finally some progress again.
I got those bolts out of the shifter levers and installed my connecting rod between the AOD and stock shifter. Also replaced the lower radiator hose with a new one for a better fit. Small steps, but finally some progress again.
A
Anonymous
Guest
Just finished getting new track rubber mounted. They're now on the car and it's ready for the first track day of the year, April 11th!
Wooooo Hooooooooooo
Wooooo Hooooooooooo
SELLERSRODSHOP
Well-Known Member
"janschutz" said:
won't matter. will probably rain on the 11th.... :roll
A
Anonymous
Guest
"janschutz" said:
Purring like a Lion with his nuts racked.
A
Anonymous
Guest
"SELLERSRODSHOP" said:
How about a little FIRE Scarecrow?
Gigantopithecus
Well-Known Member
Re: Re: What did you get done on your Stang today????
Kansas only ranks an f3 as mildly windy.
"Midlife" said:
Kansas only ranks an f3 as mildly windy.
A
Anonymous
Guest
"Gigantopithecus" said:
Tru dat
A true Kansan never comments about HOW windy it is, we only discuss wind when there is none!
A
Anonymous
Guest
"Midlife" said:
I'm golden till June 11th.
66gt350
Active Member
Started on swapping out the manual steering for the TCP power rack. Got the manual steering box out...what a pain. With the shape of the Milodon pan, I had to remove the pan to get the steering box out. Not even raising the engine was enough. Cut down the stock steering column and got it remounted. And got the KRC pump mounted.
Now, I just need to get a pan put back on, bolt on the rack and reservoir, and finally get it plumbed. With any luck, I'll be out terrorizing the neighborhood soon!!!
Now, I just need to get a pan put back on, bolt on the rack and reservoir, and finally get it plumbed. With any luck, I'll be out terrorizing the neighborhood soon!!!
rollinsmoke65
Member
I started to pull most of the engine compartment apart to clean up. Order a new air cleaner and valve covers, and now need to order new hoses and a water pump. Need to finish cleaning stuff up so I can spray the motor gloss black, then paint the rest of the engine compartment. I am hoping I can get this stuff finished up this week in the evenings.
burnout289
Member
Finished my carb rebuild. With any luck, it'll work too. Thinking I might pull the heads and clean those up next. Not much else I can do until I pull the engine.
