What block plate do I need?

[65-408]

for a 351W to a TKO600 with a Tremec AL bellhousing, have the bell housing, need a block plate and fork boot, anyone know where to get these?

 

[B67FSTB]

I know that it costs more but why don't you consider to upgrade to cable or hydraulic clutch setup?
I think its worth to make time to consider this.IMHO.

 

[65-408]

going with a mcleod HTB, but still need a block plate and was thinking a fork boot would be nice to feed the hydraulic line out...

 

[Fast68back]

I bought my plate off ebay for about $20 IIRC. I have a late model bell for my T5 and it has an aluminum cover plate that we cut a couple holes in to run the hydraulic lines for the Mcleod Hyd TO assembly.

 

[MarkStang]

But I registered Oct 3, 2008

That makes me a FOG :lol

 

[Fast68back]

Its based on post count, not register date.

 

[66gt350]

going with a mcleod HTB, but still need a block plate and was thinking a fork boot would be nice to feed the hydraulic line out...

That's what I did to run the hyd. lines out of the bellhousing. IIRC, the fork boot is just a standard re-pop boot, but I cut it down quite a bit and then basically put it in backwards -- so the part that is normally sticking out is now inside the bellhousing.

I'm running a Lakewood scattershield, so I'm using their block plate. So, can't help ya there.
-rob