• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Step by step guide to rear leaf spring replacement (finishing up question)

T

Tims65

Member
OK, so I am ditching the traction masters and replacing my 17 year old leaf springs with new Maier Racing 160 racing leafs.

Can someone outline for me the step by step process to replace my rear leaf springs?

I will be doing this in my driveway on jack stands or ramps. I have had my front suspension on and off, but have never dropped the rear leaf springs.

Thanks,
Tim
 
Re: Step by step guide to rear leaf spring replacement

I'll check Abe's post later and add if needed. Pretty simple process just take extra time when bolting the rear back. Measure, tighten, measure, tighten, measure, tighten.
 
Re: Step by step guide to rear leaf spring replacement

Pre-spray all bolts with some type of rust buster.
 
Re: Step by step guide to rear leaf spring replacement

I am watching for the topic as well.

I need to change out the leaf springs on the Trans Am at some point and wouldn't mind a refresher....it's been a while.
 
Re: Step by step guide to rear leaf spring replacement

What's needed for a tutorial. Replace one side at a time...done.
 
Re: Step by step guide to rear leaf spring replacement

"silverblueBP" said:
What's needed for a tutorial. Replace one side at a time...done.
Click to expand...

Gotta agree.....2 bolts, two U-bolts, remove, install, tighten with weight on the car....move to other side.
 
Re: Step by step guide to rear leaf spring replacement

Sorry, but with the amount of pressure the leafs have when loaded, I'd think a detailed tutorial would be good for those who have not done it before.
 
Re: Step by step guide to rear leaf spring replacement

"cmayna" said:
Sorry, but with the amount of pressure the leafs have when loaded, I'd think a detailed tutorial would be good for those who have not done it before.
Click to expand...

Woops, for got to say jack it up..........thing is you do not remove them when under pressure.
 
Re: Step by step guide to rear leaf spring replacement

"cmayna" said:
Sorry, but with the amount of pressure the leafs have when loaded, I'd think a detailed tutorial would be good for those who have not done it before.
Click to expand...

Get to typin'
 
Re: Re: Step by step guide to rear leaf spring replacement

"cmayna" said:
Sorry, but with the amount of pressure the leafs have when loaded, I'd think a detailed tutorial would be good for those who have not done it before.
Click to expand...

+1 Someone could seriously hurt themselves if they don't support the car correctly. Supports need to be under the rear frame rails to support the weight of the car. Also under the axle with the springs unloaded to support it. Do one side at a time, remove u-bolts, rear shackle bolts, then your front eye-bolt (you did remember to soak it liberally with PB blaster ;) ), if you still can't get this bolt out break out the sawzall with the tungsten carbide blades (you did get them, right, OK guess its time for that trip to HD or Lowe's) Now slide the spring out and install the new one in reverse order, minus cutting the bolt of course. Did you get new front eye bolts? You probably should even if your lucky and get the old ones out without cutting them. Now sit back and enjoy your favorite beverage. After sufficient time, wash, rinse, repeat on the other side.

Sent from my DROIDX using Tapatalk
 
Re: Step by step guide to rear leaf spring replacement

"cmayna" said:
Sorry, but with the amount of pressure the leafs have when loaded, I'd think a detailed tutorial would be good for those who have not done it before.
Click to expand...

wise man speaking !!
 
Re: Step by step guide to rear leaf spring replacement

I think this is one of those cases where it is being over thought. Jack stands under the rails, floor jack under pumpkin and get at it. The one thing no one has mentioned it just how difficult it can be to get the bolts out. Mark alluded to it by suggesting soaking things. Have BFH handy as it will probably be needed.
 
Re: Re: Step by step guide to rear leaf spring replacement

"blue65coupe" said:
Get to typin'
Click to expand...

Good enuf ;) Don't you need some more owl pics to look at?

Sent from my DROIDX using Tapatalk
 
Re: Step by step guide to rear leaf spring replacement

"Grabber70Mach" said:
Good enuf ;) Don't you need some more owl pics to look at?

Sent from my DROIDX using Tapatalk
Click to expand...

You forgot to detail the amount of measuring and checking you need to do to ensure a properly centered rear. Hoot, hoot


Oh yeah

sent from a dell using typenottalk
 
Re: Step by step guide to rear leaf spring replacement

Don't forget one of the most important 1st steps: If you've got any young 'uns, send them to Grammy's house so they won't hear you :rant :censored :censored :censored :rant as you try to bust loose the probably rusted eye bolts before you wind up cutting them out.
 
You must log in or register to reply here.
Back
Top