• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Seized Brake Line Bolt

Brorique

New Member
Hi everyone,

I'm currently trying to replace the rear brake cylinder on my 1968 Mustang Coupe V8. I've run into a snag where the bolt keeping the brake line attached to the brake cylinder has seized and will not budge. I've tried brake cleaner, WD-40, and Nut Buster and nothing has worked so far. Any advice on how to get this thing off?

Thank you
 
Heat . Take a small torch and heat the brake cylinder. Wear protection as brake fluid can burn and toxic fumes comes out the cylinder.
 
Back
Top