Need Help Identifying parts

[jking]

I don't quite know all of my old mustang stuff yet. So any help what it is and where it goes would be much appreciated.


#1


#2


#3


#4


#5


#6


#7


#8


#9


#10


#11


#12


#13


#14


#15


#16


#17---Looks like a bracket the PO made???



#18


#19




#20


#21

 

[67TXStang]

I'll start...
1) Coil spring isolator
2) ?
3) ?
4) Coil Spring Cover
5) Another Coil Spring Cover
6) Another Coil Spring Cover
7) ? A/C Parts
8) Battery Hold Down
9) Power Steering Control Valve
10) Power Steering Cylinder
11) ? Exhaust Hanger
12) ? Exhaust Hanger
13) Underdash Fresh Air Vent
14) Exhaust Hanger
15) Upper Dash Trim
16) Cowl Repair Parts
17) ?
18) Part of A/C Cover for Firewall (and unknown circular part)
19) Battery Tray
20) Remaining parts for A/C Cover (see 18)
21) Throttle assembly which mounts to firewall

 

[janschutz]

# 17 looks like a torque box

 

[Midlife]

#4,5,6: coil spring cover - goes on over fender apron below fender.
#8: battery tie down bracket
#11,12: exhaust hanger
#13: fresh air vent, driver's side
#14: exhaust hangar
#16: looks like fresh air vent lips - for repair purposes
#18: circular doo-dad looks like emergency brake wheel
#19: battery tray
#20: A/C grommets at firewall
#21: I think that is your tranny kick-down assembly

 

[tarafied1]

#18 looks like it goes in the center of the spare tire/wheel for the hold down wing nut. and 17 is a torque box.

 

[lethal289]

2 and 3 look like whats left off of some grinding wheel, or abrasive disk. I could be wrong though... Its been known to happen.

 

[Sluggo]

7 Is an expansion valve for the A/C. the u shaped clip holds the bulb to the suction line on the evaporator.

17 is the lower half of a torque box.

 

[jking]

Awesome thanks everyone for their help!

 

[gtscode]

2 and 3 look like whats left off of some grinding wheel, or abrasive disk. I could be wrong though... Its been known to happen.

Or a polishing wheel that goes in a drill chuck.

 

[daveSanborn]

In the blue tote in photo 10 with the PS ram cylinder are a couple more parts:

Brake Light Switch
Master Cylinder Pushrod

Also, be careful with the two pieces of upper dash trim shown in picture 15 as I believe they're still not being reproduced.

 

[KBMWRS]

MIA, the car. :beat