B67FSTB
The NorCal dude from Belgium
Because I am on a budget and want the best , I decided to try and make my own roller perches ( sorry john ) .
see picture how far I am in the progress.
see picture how far I am in the progress.
-
Hello there guest and Welcome to The #1 Classic Mustang forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
my attempt
- Thread starter B67FSTB
- Start date
Good job Bruno.
tarafied1
Well-Known Member
John promotes the DIY guys so no need to be sorry but I'm with johnpro... I can weld sheet metal but I won't do suspension or frame welds.
66gt350
Active Member
I with the rest, I got mine from John...I can weld, but it looks like a turkey flew over my project and deposits a large load. I've gotten quite good at grinding down welds!!
B67FSTB
The NorCal dude from Belgium
bearing housing od: 46mm id: 40 wide: 20mm shaft opening :30mm
bearing is 6203-2RS 40x17x12
Orig shaft milled down to except the bearing( 17mm).
I have another approch with another seize of bearing.
bearing housing od: 37mm id: 20mm wide: 20mm shaft opening : 30mm
bearing is 6904-2RS
Orig shaft milled down to except the bearing( 20mm).
I was a bit too fast when buying the 6203 bearings so I make 1 set with these bearings and later on I make a set with the 6904 bearings.
ps : I am not an expert in this and try this out at my own risk !!!!
IMO , if the shaft breaks , the perch will still rest ontop of the UCA.
Anyway : any remarks are welcome.
bearing is 6203-2RS 40x17x12
Orig shaft milled down to except the bearing( 17mm).
I have another approch with another seize of bearing.
bearing housing od: 37mm id: 20mm wide: 20mm shaft opening : 30mm
bearing is 6904-2RS
Orig shaft milled down to except the bearing( 20mm).
I was a bit too fast when buying the 6203 bearings so I make 1 set with these bearings and later on I make a set with the 6904 bearings.
ps : I am not an expert in this and try this out at my own risk !!!!
IMO , if the shaft breaks , the perch will still rest ontop of the UCA.
Anyway : any remarks are welcome.
buckeyedemon
Member
i built my own too. i hope they actually work (i'm sorry but i'm skeptical) because it was a lot of effort....
i got the kit from Daze.
i got the kit from Daze.
Last edited by a moderator:
70_Fastback
Hell Bent for Speed
"tarafied1" said:
B67FSTB
The NorCal dude from Belgium
Well its quite some time ( times fly by !! ) but I finally found the time to weld the roller spring perches.
As you can see , I am not an expert in welding but I think its strong enough.
Meanwhile both are painted in black.
As you can see , I am not an expert in welding but I think its strong enough.
Meanwhile both are painted in black.
apollard
Active Member
Nice looking job Bruno.
A
Anonymous
Guest
"B67FSTB" said:
Looks like GO to me!
Nice job Bruno :thu