chaser012001
66 408w, TKO600 coupe...in progress
I'm about done shaping the car with Slick Sand.
I'm about to the point where I can start to 400 block it but I was wondering what product I should use for that step?
I have SPI 2k Regular and SPI Epoxy.
The hitch, I did cut through to the metal in a couple small areas (stuff on contour ridges where the paper rubbed in). They arent big areas but I am a little paranoid about them. If 2k is what I should use for 400, should I spot shoot the cut throughs to make sure they're sealed?
Thanks in advance!
I'm about to the point where I can start to 400 block it but I was wondering what product I should use for that step?
I have SPI 2k Regular and SPI Epoxy.
The hitch, I did cut through to the metal in a couple small areas (stuff on contour ridges where the paper rubbed in). They arent big areas but I am a little paranoid about them. If 2k is what I should use for 400, should I spot shoot the cut throughs to make sure they're sealed?
Thanks in advance!