• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Vroom! Vroom!

K

Kats66Pny

Active Member
Not the best burn out. She does much better. My friend was only playing in it to test gears, make sure we didn't mess anything up when we fixed front servo leak today. Guess we fixed it right. The band didnt move and I still had 2nd gear! Last weekend we replaced the rear seal and put on a new fuel pump.

We cheated today. Instead of dropping the trans, we used a plasma cutter and cut an access hole in the floor. We'll weld it closed maybe next weekend after we make sure we fixed the leak.

Oh and we got the window regulator put in!! After 2 yrs, I can finally roll my window up! Which was a good thing because I drove her home in the rain tonight.

http://youtu.be/MZ6wGCj7UiA



Sent from my iPad using Tapatalk
 
Some pictures from today.

Since we had it, went ahead and cut out some rust.
u9ary4a8.jpg

duqebe9e.jpg


ubu9arej.jpg

ysymamah.jpg

u3e5ydy3.jpg

tatezu5u.jpg

se5uju7y.jpg


Left a souvenir
amuda5ap.jpg



Sent from my iPad using Tapatalk
 
Last edited by a moderator:
Yup, cut a hole in the floor! lol Why not. I have no interior and was a lot easier and faster than trying to drop the trans. Especially since I would have had to cut my exhaust off again to get to the cross member.


Sent from my iPad using Tapatalk
 
LOL well folks in Texas are pretty unique!

Don't laugh. It took about an hour total time to cut the floor, take off the servo, fix the gasket, and put it back on. Compared to several hours if we had dropped the trans. Took longer to install the window regulator than fix the leaking servo.



Sent from my iPad using Tapatalk
 
You must log in or register to reply here.
Back
Top