DEL65
Of The Morons
A while back, while cloning my GT, I replaced my Falcon gauges with a GT bezel. I bought the plastic gauge support and added Auto Meter Traditional Chrome gauges. I chose a volt meter instead of an amp gauge. I also added mechanical oil and temp gauges because I like the full sweep.
Other than installing stereo/amps, this was my first time doing any type of wiring. It looked complicated, but was no big deal. With patience and attention to detail anyone can do it.
For simplicity, I did not mess with the turn signal wiring, I just installed the single flasher bulb into the left signal bezel. I put a red cover on the high beam bulb and put it in the right bezel. I'll spare everyone the other install details, but for any questions drop me a note.
After
Other than installing stereo/amps, this was my first time doing any type of wiring. It looked complicated, but was no big deal. With patience and attention to detail anyone can do it.
For simplicity, I did not mess with the turn signal wiring, I just installed the single flasher bulb into the left signal bezel. I put a red cover on the high beam bulb and put it in the right bezel. I'll spare everyone the other install details, but for any questions drop me a note.
After
Last edited by a moderator:
