monkeystash
Active Member
1965, Falcon cluster w/ alt. Does a wire connect to this spade on the ignition switch? I don't have any extra wires for it. Thx.
Last edited by a moderator:
-
Hello there guest and Welcome to The #1 Classic Mustang forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Does a wire connect to this II?
- Thread starter monkeystash
- Start date
That looks like a 67 Mustang ignition switch. That spade is for the master cylinder brake indicator signal.
monkeystash
Active Member
Hmmm, I think you are right according to the part number. Can I still use it and disregard the extra spade?
Last edited by a moderator:
You sure can. I'd wrap the spade lug with electrical tape, as it will be hot during either ACC or RUN mode.
monkeystash
Active Member
Awesome, thanks Mid!
SELLERSRODSHOP
Well-Known Member
"monkeystash" said:
a little late to the game, but when i run across a spade terminal that wont get used, i usually just snap a fully insulated female connector on or use a little piece of shrink sleeve over it. that way there are no worries with heat causing electrical tape to come off later on down the road....