A while ago, I discovered the air diverter sheets that are attached to both sides of the radiator on my 2013 F250 were sagging and tearing. The OE material is some sort of mixture of rubber and dryer lint. I decided to make my own replacement set from rubber sheet. I found a set of el cheapo floor mats at the parts store and I used the one from the pass. side as a template and made a new part. Its installed and looks like it will work (pro tip: remove the grill instead of trying to shove your hand into the openings, much easier installation). Moving on the the driver side I found the diverter sheet was bigger than the other front floor mat and I need to glue the rear floor mat to the front floor mat to be able to use the OE piece as a template.
Finally, my question: what brand of rubber cement have you used that will basically 'melt' these two floor mats together so I can trim and install the new diverter without worry that it will separate? I considered using brads or small nuts/washers/bolts to ensure the two floor mats stay glued together. Ideas? Comments?
Finally, my question: what brand of rubber cement have you used that will basically 'melt' these two floor mats together so I can trim and install the new diverter without worry that it will separate? I considered using brads or small nuts/washers/bolts to ensure the two floor mats stay glued together. Ideas? Comments?