• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Help installing cut to length msd wires

I used sprak plug lubricant inside the boot then slipped the wire through. I then put on the tip and slid the boot the other direction until it was properly positioned inside the boot. I first tried to put on the tip first then put the boot on and that was a major pain in the arse.
 
Ok well that sucked took long time and lots of super lube I found some of this really old lubricant in a needle pen type dispenser in my dads tool box they really should have some type of tool to make it easier to slide the wires through
 
I honestly don't remember what I used (spit?, arm pit sweat?) when I did my MSD wires but never had a real issue.
 
"cmayna" said:
I honestly don't remember what I used (spit?, arm pit sweat?) when I did my MSD wires but never had a real issue.
Click to expand...
Craig: When I terminated your plug wires for Shag, I used silicone spray to lube the boots.........
 
I just did this exact same thing last week. I used dielectric grease on the boots and the terminals. It slid in nicely for me.
 
Help installing cut to length msd wires

Using KY will turn your wires Greek. Y do I know? I love olives.
 
Help installing cut to length msd wires

"cmayna" said:
Using KY will turn your wires Greek. Y do I know? I love olives.
Click to expand...

I think I just threw up a little in my mouth.
 
You must log in or register to reply here.
Back
Top