Author Topic: Is this the right collector reducer I need? (Read 543 times)

sigtauenus · « **on:** April, 05, 2010, 12:02:22 PM »

You can see the collector fitting I have. Its a 3 bolt movable bracket and there is a lip on the end of the header.

http://www.summitracing.com/parts/PYE-PVR16S/

This looks like it might fit, but I don't know if it would seal against my collector.

Suggestions?

Fast68back · « **Reply #1 on:** April, 05, 2010, 12:17:28 PM »

Its right, but silly expensive... I would bet a local shop could make them up for a fraction of that price.

sigtauenus · « **Reply #2 on:** April, 05, 2010, 12:46:47 PM »

Even in stainless steel?

66gt350 · « **Reply #3 on:** April, 05, 2010, 01:10:22 PM »

If you don't need stainless, I think that I have a couple of those type collectors floating around in the shop. Yours for the price of shipping. What diameter do you need?

sigtauenus · « **Reply #4 on:** April, 05, 2010, 01:52:20 PM »

Rob, thanks for the offer. I'm mating up ceramic coated headers and the Magnaflow stainless exhaust. Pre-fab'd, these Pypes brand are the only stainless collector reducers I've found that go from 3.0 to 2.5".