• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Rapid Rabbit's 70 Stang

We are getting closer. Exhaust is all mocked up. He just need to weld it yet. The floor pan and the aod tranny put up a bit a fight.

89c2ee6d622393c19089d881bc6466da.jpg

41f1fca909b99a5f40201ca930908d05.jpg

96c396abd430edfd62712fb1387b3548.jpg


d279538b48248ee9299737c77c37a06a.jpg





Fuel lines are run and just need to be finished up at the pump and filter.

Sent from my XT1058 using Tapatalk
 
Exhaust is all welded up and set. Tips are installed. I'm kind of thinking I should have gone with a different tip. The openings in the valance look a little too flat for round tips.

c7568212fd23446691462f72cc517c7f.jpg


Sent from my XT1058 using Tapatalk
 
Last edited:
Don't ask.

My first car was a Camaro when I was 16. I learned my lesson and have been mustang ever since.

Sent from my XT1058 using Tapatalk
 
No pictures, but a quick update.

Fuel lines are done, power steering lines and transmission lines done. All fluids filled up.

O2 sensors are getting welded in shortly.

Fingers crossed, we may be firing the engine next week.

Sent from my XT1058 using Tapatalk
 
Ignition switch is dead. New one should be her in a couple days. Then time to light the fire!

Sent from my XT1058 using Tapatalk
 
Switch showed up on Friday but the wiring was too short. Need to find a different one now. Ugh.

Maybe next week.

Sent from my XT1058 using Tapatalk
 
You're looking for a 70 ignition pigtail? I got those...but not the ignition switch side, only the underdash side.
 
Yeah, those are hard to find. NPD has one for $90, but states "Incl pigtail for splicing into original connector block and wire lead which must be reused."

If you need additional wire of the right colors and gauge to make the right length, I got those.
 
You must log in or register to reply here.
Back
Top